2T-3T Automatic leveling jack system
Product Description
Auto leveling device installation and wiring
1 The environment requirements of the Auto leveling device controller installation
（1） It's better mount Controller in the well-ventilated room.
（2） Avoid installing under sunlight, dust, and metal powders .
（3） The mount position must far away from any amyctic and explosive gas.
（4） Please make sure the controller and sensor without any electromagnetic interference and the other electronic instruments are easily influenced by electromagnetic interference.
2 Jacks and sensor installation：
（1） Jacks installation diagram (Unit mm)
Warning:Please install the jacks on the even and hard ground
（2） Sensor installation diagram
1) Before installing the device,please park your vehicle on a horizonal ground.Make sure the sensor be installed near the geometric center of four jacks and reach the horizontal zero degree,then fastened by the screws.
2) Installing the sensor and four jacks like the picture above. Notice:The derection Y+ of the sensor must parallel with the vehicle’s longitudinal centre line;
3.The 7- way plug connector position on the back of the control box
4. Signal lamp instruction Red light on:there are legs haven’t retracted, ban to drive the vehicle. Green light on:the legs are all retracted, can drive the vehicle, no light line short circuit(only for reference).
Details pictures
Related products
-
2T-3T Automatic leveling jack system
Product Description Auto leveling device installation and wiring 1 The environment requirements of the Auto leveling device controller installation （1） It’s better mount Controller in the well-ventilated room. （2） Avoid installing under sunlight, dust, and metal powders . （3） The mount position must far away from any amyctic and explosive gas. （4） Please make sure the controller and sensor without any electromagnetic interference and the other electronic instruments are eas...
-
66”/60”Bunk Ladder with Hook and Rubber Foot Pa...
Product Description Easy To Connect: This bunk ladder has two types of connections, safety hooks and extrusions. You can use small hooks and extrusions to make a successful connection. Bunk Ladder Parameter: Material: Aluminum. Diameter ladder tubing: 1″. Width: 11″. Height: 60″/66”. Weight Capacity: 250LBS. Weight: 3LBS. Exterior Design: Rubber foot pads can provide you with a stable grip. When you climb the bunk ladder, the mounting hook can prevent the ladder from sl...
-
6T-10T Automatic leveling jack system
Product Description Auto leveling device installation and wiring 1 The environment requirements of the Auto leveling device controller installation （1） It’s better mount Controller in the well-ventilated room. （2） Avoid installing under sunlight, dust, and metal powders . （3） The mount position must far away from any amyctic and explosive gas. （4） Please make sure the controller and sensor without any electromagnetic interference and the other electronic instruments are eas...
-
2500lb Power A-Frame Electric Tongue Jack with ...
Product Description Durable and Sturdy: Heavy-gauge steel construction ensures durability and strength; Black powder coat finish resists rust and corrosion; Durable, textured-housing prevents chips and cracks. Electric jack lets you raise and lower your A-frame trailer quickly and easily. 2,500 lbs. lift capacity, a low maintenance 12V DC electric gear motor. Provides 18” lift, retracted 9 inch, extended 27”, drop leg extra 5-5/8” lift. Outer tube dia.: 2-1/4″, inner tube dia.: 2&#...
-
3500lb Electric Camper Jacks
Technical Specifications 1.Power Required: 12V DC 2. 3500lbs capacity per jack 3.Travel: 31.5in Installation Instructions Before installation,compare the lift capacity of the electrical jack with your trailer to ensure safe operation of the jacks. 1. Park the trailer on a level surface and block the wheels. 2. Installation and connection as below diagramInstallation location of jacks on the vehicle(for reference) The wiring of the controller please refer to the above diagram In...